ADC 400F Manuale Scaricare il pdf (Pagina 8)

Chapter 1. The electronics

Figure 1-2. Pulser Output Signal

Figure 1-3. Ampliﬁer Output SIgnal

After you are happy with the signal from the ampliﬁer plug the bipolar output into the splitter. The

splitter will simply split the signal much like a "T" but will keep the 50Ω termination needed by the

pulser.

One of the splitter outputs will go into a LEMO to Ribbon Cable con- verter. This can be either a NIM

based module or a freestanding adapter. Either way the function is simple and will allow you to put the

signal onto a ﬂat ribbon cable to be plugged into the CAEN V785.

Note: Ribbon cable can difﬁcult to work with because it is easy to get it twisted and lose track, of

which end is which. To avoid this look carefully at the coloring on the cable you are using and be sure

it is plugged in the correct channel of the ADC.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 73 74

Nessun commento

ADC 400F Manuale Pagina 8